SURGE, SAFETY AND FUNCTIONAL END LINE TESTING SYSTEMS

Turnkey testing systems of:

 

High voltage test

Insulation resistance test

Ohmic resistance test with temperature compensation

Functional test

Surge Test e Winding polarity control

Partial Discharge

Automatic setting of star or delta circuit

Supply from the Grid or from internal variator or inverter based power supply

Computer and LabVIEW Based MotorTEST-Line software

Data acquisition from instruments

Automatic setting of parameters and thresholds

 

Brochure pdf

Safety tests

MEA for Line

FAST DYNAMIC TEST SYSTEMS (TORQUE-SPEED, 3 SECONDS)

OF ELECTRIC MOTORS IN PRODUCTION LINES

Meeting European Standards IEC 60034-2-1 and USA standards IEEE 112/113

Nowadays electric motors are subject to 100% inspection following manufacturing.

The M.E.A. Inertial Dynamometer gives the ultimate solution where the conventional dynamometer cannot, since the usage of the conventional dynamometer is often impracticable due to time constraints, cost, and complex setups.

 

Inertial Dynamometer devices are the ideal testing solution for every type of electrical motor, providing real measurements of the motor output without a usage of modeling. Due to the very fast testing cycle (less than 5 sec) and accuracy of M.E.A. Inertial Dynamometer devices, we have developed our MotorLine systems to meet the demands of testing 100% of the motors on the assembly/production line.

 

M.E.A. Inertial Dynamometer devices for production line can be manual or fully automatic.

 

M.E.A. turnkey customized systems include:

·        Full conventional motor performance test, from starting to no load speed

·        High Voltage Test

·        Insulation Test

·        Protective Wire Test

·        Vibration and Noise level

 

Brochure pdf

 

 

INTESYS Srl - Testing Systems

Viale Pasubio, 25/4 - 36030 Caldogno (Vicenza) – tel +39 0444 905440 fax +39 0444 1830 932 - skype: intesyssrl - info@intesys-srl.it