of gearboxes and transmissions

Functional testing,   safety and   end-of-line surge

Rapid end-of-line torque-speed testing (MEA method)

MotorTest Retrofit

Mechanical, electrical, electronic and software reconditioning of obsolete test benches for electric motors.

MotorTest Retrofit

Replacement of eddy current braking element with inverter-driven brake motor system in regenerative configuration

Replacement of load cell with torque transducer

Replacement / calibration of load cells

Review and calibration of eddy current brake control electronics

Mechanical adaptation to safety regulations with certificate

Replacement of the
control and data acquisition system

The obsolete control system is replaced with a completely new control and data acquisition system that follows market standards.


MotorTEST LabVIEW® Software enables the complete characterisation of electric motors on motor brake benches and is compatible with a wide range of market-standard control/data acquisition systems and instrumentation.

Measurable quantities: motor revolutions, torque, power output, voltages, currents, absorbed and apparent power, power factor, efficiency, slip, mains frequency, motor winding resistances, temperatures. Database of engine and brake data: database in MS Access format into which the operator enters both the test bench settings and the registration data of the engines to be tested. The parameters selected before testing will automatically set the inverter configuration of the braking motor and the inverter configuration of the motor to be tested (high-frequency motors)

This site is registered on as a development site.